3Racing Sakura Zero SAK-36/WO Rear Graphite Shock Tower - Track Upgrade  [SAK-36/WO]

3RACING Sakura Zero Rear Graphite Shock Tower - SAK-36/WO
Price:
CAD$17.36
Brand:
3Racing
Model:
SAK-36/WO
Condition:
Brand New
Write a review

Graphite upgrade for Sakura Zero handling

The 3Racing Sakura Zero Rear Graphite Shock Tower - SAK-36/WO is a practical upgrade for drivers who want firmer rear-end control. Made from quality graphite, this tower is built to improve stability and withstand regular track use.

Why graphite matters for handling

Graphite construction delivers a strong yet lightweight mounting point for the rear shocks, trimming mass compared to heavier materials. That reduced weight and increased stiffness help the car respond cleaner through corners and under braking.

Designed to fit the Sakura Zero chassis

This part is engineered to match the Sakura Zero chassis contours and mounting pattern, allowing a straightforward swap into existing setups. Accurate fitment keeps suspension geometry intact while upgrading component strength.

Durable upgrade for active racers

Whether running club races or practice sessions, the 3Racing Sakura Zero Rear Graphite Shock Tower stands up to repetitive impacts and heat from hard use, helping maintain consistent rear suspension performance.

Will this fit a standard Sakura Zero without modifications?

This tower is manufactured to the Sakura Zero mounting pattern and will fit standard chassis layouts. Minor setup tweaks may be needed to match your shock positions.

Does graphite change shock tuning requirements?

Graphite adds stiffness, which can alter roll behaviour slightly. Expect to revisit spring rates and damping to fine tune balance after installation.

Is special hardware required to install this tower?

Installation typically uses the stock mounting screws and shock hardware from the Sakura Zero. Check existing fasteners for wear and replace if necessary.

Copyright © 2008-2025 rcjaz.ca All rights reserved