3Racing SAK-X21 Sakura XI Aluminum Axle Pin Holder - Race Ready  [SAK-X21]

3RACING Sakura Zero Aluminium Axle Pin Holder for Sakura XI - SAK-X21
Price:
CAD$4.47
Brand:
3Racing
Model:
SAK-X21
Condition:
Brand New
Write a review

Precision Upgrade for Sakura XI

The 3Racing Sakura XI Aluminum Axle Pin Holder, model SAK-X21, is made to improve the axle mounting on your Sakura XI chassis. Built in aluminium for better wear resistance, this pin holder helps keep axle play to a minimum so your car tracks cleaner through corners.

Built for Lasting Service

This axle pin holder replaces the softer stock pieces with a tougher aluminium unit, reducing deformation under load and extending service life. The stronger construction supports consistent handling so lap times stay repeatable session after session.

Fitment and Quick Swap

Designed specifically for the Sakura XI, the SAK-X21 installs without major changes to your setup. Installation is straightforward and lets you return to the track fast while keeping original geometry intact.

Will this fit earlier Sakura variants?

The SAK-X21 is cut for the Sakura XI mounting points. Some older Sakura models may require checks for hole spacing differences before fitting.

Do I need special tools to install it?

Basic RC tools such as hex drivers and pliers are sufficient. The part is made to swap in using standard fasteners already on the car.

Will this affect handling setup?

This upgrade reduces flex at the axle pin mount which can tighten steering response slightly. Check toe and camber after fitting to confirm your preferred balance.

Copyright © 2008-2025 rcjaz.ca All rights reserved