3Racing SAK-D511 13T Metal Bevel Gear Upgrade for Sakura D5S  [SAK-D511]

3RACING Sakura D5S Parts 13T Metal Bevel Gear (1.0 Metric Pitch) - SAK-D511
Price:
CAD$7.86
Brand:
3Racing
Model:
SAK-D511
Condition:
Brand New
Write a review

Stiffen the Sakura D5S Drivetrain with a Robust 13T Bevel Gear

For builders and tuners looking to strengthen their setup, the 3Racing SAK-D511 13T Metal Bevel Gear is a direct upgrade for the Sakura D5S. This precision-engineered metal gear is made to stand up to regular use while keeping power delivery smooth. Its 1.0 metric pitch helps ensure consistent meshing and predictable driveline behaviour on both track and practice sessions.

Advantages of Choosing Metal over Plastic

Metal bevel gears such as the 3Racing SAK-D511 deliver longer service life and higher resistance to stress than stock plastic parts. The 13-tooth layout helps spread load through the drivetrain more evenly, which can translate to steadier acceleration and improved control during hard driving.

Fitting Notes and Maintenance Advice

When fitting the 3Racing SAK-D511 into a Sakura D5S, keep mating parts clean and inspect bearings and pinion alignment to avoid premature wear. Check meshing and endplay after the first few runs, and perform routine inspections to maintain quiet, efficient operation.

Can this gear fit other kits with the same pitch?

The 3Racing SAK-D511 is made for the Sakura D5S chassis. It may fit other models that share the same 1.0 metric pitch, but you should confirm clearances and shaft dimensions before installing.

How should I inspect the gear for wear?

Look for chipped teeth, rough contact surfaces or increased backlash. Inspect after a few running sessions and after any hard impacts to catch issues early.

Any tips to reduce drivetrain noise?

Ensure correct pinion alignment and bearing condition, set the gear mesh with a small running clearance, and lubricate contact points lightly to reduce noise and wear.

Copyright © 2008-2025 rcjaz.ca All rights reserved