3Racing SAK-D5609 Aluminum Rear Bulkhead for Sakura D5S - Drift Upgrade  [SAK-D5609]

Stiffen the Sakura D5S Rear End with 3Racing SAK-D5609

The 3Racing SAK-D5609 Aluminum Rear Bulkhead is a machined upgrade for the Sakura D5S chassis that increases toughness and refines handling. Made from quality aluminum, this bulkhead reduces flex and holds suspension geometry under load, helping you maintain cleaner lines through long drift runs. Its precise profiling ensures reliable alignment with stock mounting points so you can swap it in without guesswork.

Benefits of the SAK-D5609 Rear Bulkhead

Swapping the stock plastic part for this 3Racing aluminum unit gives a noticeable boost in rear stability and consistency. Reduced movement at the rear end means improved throttle response and more predictable slides, which helps when dialing in drift setups or experimenting with weight balance. This part suits drivers focused on stable, repeatable performance.

Fitting Notes and Maintenance

Fitting the SAK-D5609 is straightforward due to its accurate dimensions. Use proper hex drivers and check screw torque to keep the bulkhead seated correctly. Periodic inspections for loose fasteners and contact wear will extend service life, especially after hard track sessions.