3Racing SAK-D533/225 Sakura D5 Lite 225mm Fiber Chassis  [SAK-D533/225]

3RACING Sakura D5 Lite Fiber Main Chassis-225mm - SAK-D533/225
Price:
CAD$13.93
Brand:
3Racing
Model:
SAK-D533/225
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - 3Racing - Sakura D5 / D5S Parts category
Write a review

Engineered light chassis for better balance

The 3Racing SAK-D533/225 fibre main chassis is made to upgrade Sakura D5 models with a focused blend of stiffness and low mass. Its 225mm layout promotes crisper weight transfer and a firmer platform for suspension geometry, helping drivers fine tune handling without adding unnecessary bulk.

Improved on-track stability and response

Using quality fiber material, the SAK-D533/225 reduces unsprung and overall mass to aid acceleration and turn-in. The chassis offers a consistent flex pattern that supports stable high speed lines and responsive steering feel, useful for tight club racing or practice laps.

Direct fit for Sakura D5 platforms

This main chassis is cut to match Sakura D5 and D5S mounting points, allowing a straightforward swap into existing builds. Minimal trimming or extra brackets are needed, so you can focus on setup and electronics rather than fabrication.

The SAK-D533/225 matches factory D5/D5S mounting points. If you have aftermarket arms or bulkheads, check alignment and hole positions before fitting; slight shims or different screws may be needed.
Inspect for cracks after hard impacts and clean debris with mild detergent. Avoid strong solvents that could weaken the fiber. Replace if structural damage is visible.
A stiffer chassis often benefits from slightly softer springs or adjusted damping to retain traction; start with small changes and log handling differences to tune for your track conditions.

Copyright © 2008-2025 rcjaz.ca All rights reserved