3RACING Titanium Droop Gauge -4 to 10mm ST-004/TI - Precision Setup Tool  [ST-004/TI]

3RACING Droop Gauge -4 to 10mm - Titanium - ST-004/TI
Price:
CAD$10.47
Brand:
3Racing
Model:
ST-004/TI
Condition:
Brand New
Write a review

Fine tune suspension with the 3RACING ST-004/TI

The 3RACING Titanium Droop Gauge -4 to 10mm ST-004/TI is a compact titanium tool made for accurate suspension tuning on RC cars. It measures droop across the -4 to 10mm range to help you establish repeatable ride height settings for improved handling and predictable lap times.

Practical uses for setup sessions

Use this gauge when dialing in roll center and suspension travel to match track conditions. Accurate droop checks let racers maintain consistent performance between runs and simplify comparisons when changing springs or shock oil.

Titanium build for frequent use

Made from titanium, the droop gauge is both light and strong, resisting wear from workshop use. Its durable finish stands up to regular handling during setup and transport so you can rely on the same readings over many sessions.

Which scales work best with this droop gauge?

This tool is ideal for 1/10 scale cars where droop settings fall in the -4 to 10mm span, and it can be used on other scales if those measurement ranges match your setup requirements.

How do I get a consistent droop reading?

Place the gauge under the chassis at the specified reference point, settle the car on its wheels, then record the measurement. Repeat the check after any suspension changes to confirm consistency.

Any care tips for the titanium surface?

Wipe with a soft cloth to remove dirt and avoid abrasive cleaners. Titanium is corrosion resistant, but keeping the gauge clean helps preserve accurate markings and a smooth surface.

Copyright © 2008-2025 rcjaz.ca All rights reserved