3Racing SAK-D6822/RE Auper D6 Rear Upper Arm - Blue Anodized Upgrade  [SAK-D6823/BU]

Price:
CAD$26.07
Brand:
3Racing
Model:
SAK-D6823/BU
Condition:
Brand New
Available in warehouse
Write a review

Strength and fitment for the Auper D6

The 3Racing SAK-D6822/RE Aluminum Rear Upper Arm is machined to match the Auper D6 chassis and replace the standard plastic arm with a tougher alloy option. Built from quality aluminum, it is aimed at drivers who run often and need a longer lasting part.

Stiffer suspension and clearer feedback

The aluminum arm cuts flex compared with stock plastic, giving more consistent handling and improved corner exits. The blue anodized finish helps protect the surface from scuffs and corrosion during heavy use.

Fine tuning for different track surfaces

Dimensionally accurate construction lets you adjust camber and roll centre settings with confidence so the car responds predictably on carpet or asphalt. Small changes to arm mounting can yield noticeable handling differences.

Will this arm fit earlier Auper D6 variants?

The part is designed for Auper D6 geometry, so verify your chassis revision before fitting; some older variants may need small adjustments to accept the arm.

Do I need different screws or hardware to install it?

In most cases you can use the original hardware, but check for any tight clearances and replace stripped screws with quality fasteners if required.

How does the alloy affect cornering feel?

The increased rigidity reduces unwanted flex, delivering firmer turn-in and more predictable mid corner balance, which is useful for lap consistency.

Copyright © 2008-2025 rcjaz.ca All rights reserved