3RACING 64 Pitch Spur Gear 107T Ver.2 - 3RAC-SG64107/V2 Track Tuner  [3RAC-SG64107/V2]

3RACING 64 Pitch Spur Gear 107T Ver.2 - 3RAC-SG64107/V2
Price:
CAD$6.06
Brand:
3Racing
Model:
3RAC-SG64107/V2
Condition:
Brand New
Write a review

Dial in drivetrain accuracy with 3RACING 3RAC-SG64107/V2

The 3RACING 64 pitch spur gear 107T Ver.2 is a compact upgrade for RC drivers who want tighter gear engagement and steadier power delivery. Its fine tooth spacing promotes consistent meshing to keep drivetrain losses low during spirited laps.

Finer Tooth Profile for Smoother Meshing

Using a 64 pitch design provides a more refined tooth form that helps spread load across more contact points. The 107T count is a good option when aiming for higher top speed while maintaining predictable handling on the track.

Fitment and Typical Applications

Made for many 1/10 scale setups, the 3RACING 64 Pitch Spur Gear 107T Ver.2 fits common touring and on-road chassis. It works well in both tuned race builds and upgraded club cars where precise gearing matters.

Built for Regular Use

Manufactured to meet hobbyist expectations, this spur gear is designed for repeated use under demanding driving sessions. Routine inspection and correct mesh will help prolong service life and reduce replacement frequency.

It fits most 1/10 scale touring cars that accept a 64 pitch spur. Check your chassis manual for shaft diameter and mounting pattern before installing.
Start with a small paper shim between pinion and spur, then tighten and back off to achieve a snug, uniform contact across the tooth face. Recheck after a short run-in.
Keep the gear free of grit, inspect teeth for wear after impacts, and ensure correct mesh and pinion alignment to avoid premature damage.

Copyright © 2008-2025 rcjaz.ca All rights reserved