Precision Upgrade 3RACING 64 Pitch 57T Pinion Gear with Hard Coating (7075) - 3RAC-PG6457  [3RAC-PG6457]

3RACING 64 Pitch Pinion Gear 57T (7075 w/ Hard Coating) - 3RAC-PG6457
Price:
CAD$6.06
Brand:
3Racing
Model:
3RAC-PG6457
Condition:
Brand New
Write a review

Improve your RC gearing with a durable 57T pinion

The 3RACING 64 Pitch Pinion Gear 57T is a solid upgrade for hobbyists wanting cleaner gear engagement and longer service intervals. Machined from 7075 aluminum and finished with a hard coating, it delivers improved wear resistance and consistent contact under load.

Built for accuracy and longer life

This pinion focuses on precision and longevity. The 7075 aluminum core gives strength without excess weight, while the hard coat helps cut friction and slow down tooth wear, making it a dependable component for regular track sessions.

Fitment and best uses

The 64 pitch, 57 tooth profile matches many 1/10 on-road gear setups and provides a sensible trade off between torque and top speed for paved track running. Confirm mesh and shaft fitment before final installation.

Can I use this pinion on a brushed motor setup?

Yes. The 3RACING 64 Pitch Pinion Gear 57T works with brushed and brushless motors as long as the pitch, tooth count, and bore size match your spur gear and motor shaft.

Do I need special tools to change the pinion?

Basic tools like a hex driver, feeler gauge or shim and a small wrench are normally enough. Proper mesh setup is the key, not specialised tooling.

How should I check gear mesh after installing?

Set a moderate pinion-spur mesh using a bit of paper between gears, rotate by hand to confirm smooth contact, then run at low throttle and recheck for binds or excessive play.

Copyright © 2008-2025 rcjaz.ca All rights reserved