3RACING 3RAC-PG6453 64 Pitch 53T Pinion Gear 7075 Hard Coated  [3RAC-PG6453]

3RACING 64 Pitch Pinion Gear 53T (7075 w/ Hard Coating) - 3RAC-PG6453
Price:
CAD$6.06
Brand:
3Racing
Model:
3RAC-PG6453
Condition:
Brand New
Write a review

Upgrade your drivetrain with the 3RACING 3RAC-PG6453

Hobbyists looking for a durable, precise pinion will find the 3RACING 3RAC-PG6453 a solid option. Machined from 7075 aluminium with a hard coating, it balances low weight and toughness to help your 1/10 scale drivetrain run cleaner under load.

Durability and wear resistance for club runs

The 53T 64 pitch profile is built to resist wear while keeping a light feel in the drivetrain. The hard coating reduces friction and helps maintain gear geometry through extended track sessions, so you see fewer replace cycles between events.

Simple fitment for 1/10 scale cars

This pinion is suitable for most 1/10 scale RC cars and is straightforward to fit during an upgrade or maintenance swap. It works well for racers and weekend drivers who want a reliable replacement gear that holds up under usual running conditions.

Is the 3RACING 3RAC-PG6453 good for high speed runs?

Yes. The 7075 aluminium core and hard coating help resist wear and heat, making the pinion suitable for higher RPM operation when matched with the correct spur and motor gear ratio.

Will this fit different motor pinions and setups?

It is designed for standard 64 pitch systems common on 1/10 vehicles, so it will work with many motor and spur combinations that use the same pitch. Check gear mesh and shaft fitment before finalising installation.

Any tips for installation and maintenance?

Set gear mesh carefully with a shim or paper method, use a small amount of suitable grease on bearings, and inspect teeth for scoring after a few runs to confirm correct seating.

Copyright © 2008-2025 rcjaz.ca All rights reserved