Yokomo Y2-303IGA Graphite Idler Shaft Lightweight Upgrade for YD-2  [Y2-303IGA]

Lightweight Graphite Idler for YD-2 Handling

The Yokomo Y2-303IGA Graphite Idler Shaft is a precision machined component built for the YD-2 chassis. Manufactured from quality graphite, this idler shaft trims gearbox mass to boost agility and lower the centre of gravity. Those changes help drivers achieve crisper corner entry and steadier mid-corner balance.

Graphite Benefits for Race Setups

Graphite gives an excellent strength to weight ratio, making it a smart choice where lower mass is needed without sacrificing toughness. Fitting the Yokomo Y2-303IGA helps deliver a more responsive chassis and improved stability, letting you carry speed through technical sections.

Fitting and Care Notes

When fitting the idler shaft, check alignment and secure fasteners to avoid binding. The lightweight nature of graphite simplifies installation but routine checks will protect performance and extend service life. Keep mating surfaces clean and inspect for wear after hard sessions.