Factory Pro FP-O-DB3228B Long Life 76T/228 Belt for RX-10F 3.0  [FP-O-DB3228B]

Price:
CAD$18.10
Brand:
Factory Pro
Model:
FP-O-DB3228B
Condition:
Brand New
Write a review

Reliable drive belt for RX-10F 3.0

The Factory Pro FP-O-DB3228B Long Life Drive Belt is made for the RX-10F 3.0 and uses a 76T/228 tooth profile to give smooth, consistent power transfer. It is produced to resist wear during regular club sessions and track running.

Fit and compatibility notes

This 76T/228 belt is intended as a direct replacement for RX-10F 3.0 layouts and offers a close fit for standard pulley spacing. Constructed from durable materials, it helps reduce downtime when replacing worn belts.

Setup and upkeep

Set belt tension to avoid slippage and check alignment after the first runs to ensure even wear. Regular inspections for tooth damage or glazing will let you replace the belt before it affects performance.

Can this belt be used on modified RX-10F variants?

The belt is designed for standard RX-10F 3.0 geometry and pulley spacing. If your chassis has aftermarket pulleys or altered spacing, check measurements and tooth count before fitting.

How can I tell when the belt needs replacing?

Inspect for cracked or rounded teeth, excessive stretch, or a glazed surface. If the belt slips under load or shows visible damage, replace it to avoid drivetrain issues.

What tools help with a proper install?

A set of hex drivers, a small flat screwdriver for alignment and a belt tension gauge or simple feel test are useful. Re-tension after a short break-in run for best results.

Copyright © 2008-2025 rcjaz.ca All rights reserved